ACRYL-PUTZ ST 10 START

ACRYL-PUTZ ST 10 START - Finish putty

PRODUCT DESCRIPTION:

Snow-white finish putty with excellent adhesive properties. Does not show any signs of shrinkage, dries quickly, does not crack even with thick layers (to 3 cm – with single cracks),easy to grind. When using this finish putty, walls and ceilings obtain ideally smooth and easy-to-paint surface.

APPLICATION:

It’s especially recommended for finishing and renovation works of interior premises, particularly to all-surface smoothening of walls and ceilings, jointing plaster cardboard panels by reinforced tape, levelling huge roughness and cracks on the surface of plasters, wooden panels, wood-based materials as well as levelling surfaces made of bricks and concrete. Thanks to innovative formula it can be used as a topcoat without necessity to use ready-to-use finish putties.

Micro-fillers

ACRYL-PUTZ®  ST10 START finish putty recipes are based on macromolecule fillers – their diameter is scarcely 63 micrometers. Thanks to this, the putty fills in cracks carefully as well as makes ideal ready-to-paint smooth surfaces.

Enhanced durability

ACRYL-PUTZ® ST10 START is manufactured on the basis of high-class gypsums which in connection with other ingredients constitute durable high resistant layers. The putty has excellent durable parameters – during testing crushing strengths estimated – 2.4Mpa and compressive strengths estimated 5.6Mpa!

Surface preparation

• smoothing-down surface must be solid, dry, dust, grease, contamination free
• all steel elements coming into touch with the putty must have anticorrosive protection
• in order to reinforce the surface it is recommended to prime it by ACRYL-PUTZ®
• smooth concrete surfaces are to be primed by PA 10 FOVEO TECH primer
• plaster cardboard panels must be fixed on walls or ceiling in accordance with assembly procedures

Product preparation

• estimated to use dry putty mass is to be put inside of a container with water, around 1 kg of dry mass for 0.3l of water and stirred continuously
• the content of the container must be stirred carefully by a low-speed stirrer until obtaining homogenous, easy-to-apply mass without lumps
• ready-to-use putty mass must be stirred again after 5 minutes and applied by putty knife or stainless steel or plastic float or by hydrodynamic spraying
• ready-to-use putty mass is applicable for about 1 hour
• each putty preparation must be performed by clean tools and containers

Application

• single layer should amount to 1-3 mm
• do not use when the layer thickness does not exceed 1mm
• in the event of bigger single cracks it is allowed to apply single layers even of 3cm thickness
• dry surfaces are to be grinned by sandpaper, grinding sponge or net of 100/150 gradation, dedusted and painted
• Applying the putty mass to joints of plaster cardboard panels
• stirred putty mass with water is to be applied upon screws and joints by putty knife
• application upon joints should be performed in such a way so that paper tape or net can be put upon the applied putty between the panels on still wet surface
• the tape is to be put bulge to the walls so that centre of its width runs along the joint
• by using the putty knife remove air bubbles under the tape by pressing it into new applied putty mass
• after the joints have dried, apply another layer of putty by using a wider putty knife